20 to 60 Degree C. Motor Type 3 Pole Ferrite. Operating Speed 4.8V . 0.23sec 60 degrees at no load. Potentiometer Drive Indirect Drive. Operating Speed 6.0V . 0.19sec 60 degrees at no load. Bearing Type Plastic Bearing. Stall Torque 4.8V . 44 oz in. 3.2kg.cm . Gear Type All Nylon Gears. Stall Torque 6.0V ..You can mix Futaba servos with an Airtronics receiver, mix Hitec JR servos with a Futaba receiver, etc. as long as you are careful about polarity. In Futaba, Hitec, and JR Radio servos, the servo and battery connections have the same polarity and signal wiring, although the connectors are slightly different. One thing to .Note This plug can be accidentally plugged into a receiver in reverse. If this happens, no damage will occur, the servo will simply will not work. If you receive a servo and it does not work, make sure that you have plugged it in correctly. servo connector. All of our Futaba servos come with the “J” or Futaba connector..I require an accurate reference to SERVO CONNECTOR information. I would like to offer the lighting kit to accomodate every possible receiver type and have ordered Futaba, Airtronics, and JR type connector blocks and need to know if there are any other types, or which of the above three work for other .About any technology CMOS, TTL,. Discreet Components to drive the control line. A separate power wire supplies the power to the servo. The ground for power is also used as the ground for the control line. Although there are only three wires, manufacturers haven ‘t standardized the pinouts. Most connectors are wired the .
Some of the in’s and out’s of Servo Wiring About 1991 or soon after, most of the major brands ofog servos became compatible with each other..
Disclaimer: The picture about Futaba Servo Pinout, we present here is not the result of our work, we get it from various sources of public domain. So if you feel that the image we present here is copyrighted and should not be displayed on our website, please contact us and we will remove it. thank you